-
-
-
What knob controls the input signal to the board? *
-
Once the signal enters the board, what is the desired level? *
-
Where do you check for that level? *
-
What does 48V stand for? *
-
What is the 48V button used for? *
-
What is the ∅ button used for? *
-
What does the "Pad" button do? *
-
What would you use the ∅ button for? *
-
-
-
What is the frequency range that CDs are said to reproduce? *
-
Which one of these frequencies will only come out of the subs? *
-
What does 100Hz roll off or 100Hz high pass filter mean? *
-
What would you use the 100Hz roll off or 100Hz high pass filter for? *
-
What frequency range is the vocal range *
-
When axes 1 thru 4 are set to pre-fader, the channel fader affects the signal to the aux send? *
-
What should the monitor sends be set on? *
-
What send do you use for effects *
-
If you wanted to listen to the channel input signal, what button would you use? *
-
There are 3 ways to bring an item out in the mix
The level, the sound texture, and the placement. What controls on the board would you use?
-
-
-
-
-
-
We mentioned earlier the 3 ways to bring thing out in the mix. There is another realm of mixing called "depth". What would you use to create depth in the mix? *
-
-